PACTOR is an evolution of both AMTOR and packet radio;[1] its name is a portmanteau of these two technologies' names.
PACTOR uses a combination of simple FSK modulation[citation needed], and the ARQ protocol for robust error detection and data throughput.[citation needed] Generational improvements to PACTOR include PACTOR II, PACTOR III, and PACTOR IV which are capable of higher speed transmission. PACTOR is most commonly used on frequencies between 1 MHz and 30 MHz.[citation needed]
PACTOR (Latin: The mediator) was developed by Special Communications Systems GmbH (SCS) and released to the public in 1991.[1]
PACTOR was developed in order to improve the reception of digital data when the received signal was weak or noisy.[1] It combines the bandwidth efficiency of packet radio with the error-correction (CRC) and automatic repeat request (ARQ) of AMTOR. Amateur radio operators were instrumental in developing and implementing these digital modes.[citation needed]
PACTOR radio equipment consists of an HF transceiver, a computer and a terminal node controller.[citation needed] Software running on the computer drives the terminal node controller.[citation needed] The most commonly used amateur program for this purpose is Airmail.[citation needed]
PACTOR is a set of standardized modes used by radio operators for FSK radioteletype transfer of digital information over shortwave bands.[3]
Effective radio-frequency communications over long distances over hostile radio paths require that special attention be paid to the rate at which data is repeated and error correction.[4]
To reduce the amount of data sent, on-line data compression is utilized, along with memory ARQ error correction.[5]
Depending on the version of PACTOR protocol used and the radio-frequency conditions, PACTOR transmission speeds range from 20 to 5200 bits per second (bit/s; net rate) or 9000 bit/s gross rate utilizing speed 10 (32-QAM).[6][7]
Pactor I is 340HJ2D or 440HJ2D (at a symbol rate up to 200 symbols per second).[8]
Pactor II is 450HJ2D (at a symbol rate of 100 symbols per second).[8][4][9]
Pactor III is 2K20J2D (at a symbol rate of 100 symbols per second).[8][10][11]
Pactor IV is 2K20J2D or 2K40J2D (at a symbol rate up to 1800 symbols per second).[8][12][7]
Availability and monitoring
A robust network of PACTOR stations has been established to transfer data between radio stations and the Internet, extending Internet access to sea-based and other isolated users, led by volunteers involved with Winlink, under the auspicies of ARSFI (a Florida-based non-profit organization).[13]
Pactor modes other than level 1 (P1) are not open source,[14][15] but are publicly documented[16] and can be monitored and decoded easily over the air by third parties using free Raspberry Pi software ("PMON for Raspberry Pi")[17] or PMON utility on the modem itself.[18]